NOTE! This site uses cookies and similar technologies.

If you not change browser settings, you agree to it.

I understand

CART_SCA_WGTD

Weighing cartridge (Metrological seal + Subd9 connector)
Technical Datasheet Cartridge optionsTechnical Datasheet Cartridge options
Description

The weighing cartridge for digital load cells allows the equipment to measure weights based on the signal delivered by a digital load cell system. It contains all the elements necessary to ensure that the weight is measured independently of the equipment in which it is inserted and that it is always metrologically correct.


It comes with a memory with all the parameters related to the configuration of the digital load cells system connected (number of load cells, capacity, etc.) and related to the weight measures (calibrations, linearization points, filters, etc.) that can be configurated in the equipments. This memory has a mechanical write lock system that blocks (provided it is active) any alteration of any parameter stored in it.


The digital weighing cartridges are inserted in the equipment in position 1. There are two versions of the weighing cartridge for digital load cells based on the connector:


CART_SCA/WGTD-IP
The cartridge is connected to digital load cells through a 4-pin female round connector, as shown below:

 

PIN

SIGNAL

4 WIRES

1 Positive power (V+) Red
2 SCL Green
3 SDA White
4 Negative power (V-) Black

 

CART_SCA/WGTD
The cartridge is connected to digital cells through a 9-pin male SUB-D connector, as shown below:

 

PIN

SIGNAL

4 WIRES

1 SDA White
3 Positive power (V+) Res
5 Negative power (V-) Black
9 SCL Green

Reviews

There are yet no reviews for this product.